italyger.blogg.se - Wireshark mac capture all wifi traffic

Part 1 is the authentication of the client.

An important part of this process is the traffic flow between the authenticator and authentication server (the blue line) The virtual uncontrolled port on the authenticator opens and allow EAP-traffic through (the red line).

Phase 2: Starts with the authenticator (WLC) sends request identity to the supplicant (client) and the supplicant respond.

Phase 1: Establish 802.11 data link: probe request/response, authentication and association between the client and the AP.

The traffic flow in this network is like this Mac-address on wifi-nic: 5c 51 81 22 4d a1 – WLC (authenticator): Wlan with wpa2-aes and 802.1X, access point in flexconnect with native vlan to 1716 and the flex WLAN mapped to vlan 2000

Free Radius server, configured for EAP-PEAP and EAP-MSCHAPv2 – Router, two LAN-subinterfaces and internal dhcp-server for both subinterfaces, nat against internet – SW2, all vlans enabled on all trunkports – SW2 with AP, trunk against AP with vlan 1716 (ap management) and vlan 2000 (flex WLAN), 1716 as native vlan How to enable monitor mode mon0? sudo airmon-ng start wlan0įound 5 processes that could cause trouble.How to capture frames in Wireshark on a network with WPA2 Enterprise and AP in FlexConnect using MacBook Iface MTU Met RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR FlgĮth0 1492 0 117205 0 0 0 96232 0 0 0 BMPRU Promiscuous mode setting - trying both on and off in monitor mode.Īny body please help to get the wireless network traffic to get my all the request to capture to my team members in the same network. I don't find to set the promiscuous mode. I' using wireshark 2.2.3, I want to capture all wireless network traffic using wireshark.Įdit -> Preferences -> Protocols -> IEEE 802.11 -> New -> wpa-pskĪnd in the Key box: " AP:password", But I get an Invalid key format error.